What cooling system is required for a 200kW 400V Load Bank during continuous operation

2026-11-20

Designed for full-load testing of backup generators, UPS systems, and off-grid solar storage stations, the ‌200kW 400V Load Bank‌ converts massive amounts of electrical energy into heat during long-duration performance validation. At ‌RST‌, we engineer every thermal management component of these units to maintain stable operating temperatures, prevent overheating trips, and guarantee consistent load accuracy even under 8+ hour non-stop operation.

200kW 400V Load Bank

Core Cooling System Design Requirements

A properly configured cooling system is critical to avoid hotspots on resistive elements, protect internal control circuits, and extend the service life of the ‌200kW 400V Load Bank‌. ‌RST‌ follows strict IEC 61010 safety standards for all thermal design specifications:

  1. High-volume axial fans with synchronized speed control to deliver uniform airflow across all resistive load banks
  2. Dedicated independent air duct structure that isolates hot exhaust air from recirculating back into the unit’s air intake
  3. High-temperature cut-off sensors installed near core heating components to trigger automatic alarm or shutdown at 120°C
  4. Corrosion-resistant aluminum fin heat sinks mounted on power distribution components to reduce localized temperature rise

Standard Cooling Configuration Reference Table

Operation Scenario Required Cooling Type Airflow Volume Maximum Allowable Ambient Temperature
Indoor fixed installation Forced air cooling 12000 m³/h 40°C
Outdoor mobile trailer use Forced air + weatherproof vent 15000 m³/h 45°C
High-temperature tropical area Enhanced dual-fan forced air 18000 m³/h 50°C

200kW 400V Load Bank FAQ

  • ‌What happens if the cooling airflow of a ‌200kW 400V Load Bank‌ is insufficient during continuous full-load operation?‌
    Insufficient cooling will cause rapid temperature rise on the resistive elements, leading to load value drift, automatic overheat protection shutdown, or even permanent burnout of the heating wires in severe cases, completely interrupting your power system testing process.
  • ‌Can a ‌RST‌ ‌200kW 400V Load Bank‌ operate reliably in outdoor rainy conditions with its forced air cooling system?‌
    All our outdoor-rated models are equipped with IP54 weatherproof louvers on both air intake and exhaust vents, which block rain and dust while maintaining full cooling airflow, ensuring stable continuous operation even in light rain environments.
  • ‌Does the cooling fan system of the ‌200kW 400V Load Bank‌ require regular routine maintenance?‌
    It is recommended to clean fan blades and air inlet filters every 3 months, and check fan motor bearings for lubrication once a year. This simple maintenance routine can extend the service life of the entire cooling system by more than 5 years.

If you need custom cooling configuration, on-site thermal performance testing, or full-load commissioning services for your power system testing project, ‌contact us‌ today. The ‌RST‌ power testing engineering team will provide a fully optimized ‌200kW 400V Load Bank‌ cooling solution that guarantees 100% stable continuous operation for all your long-duration load testing requirements.

Previous:No News
Next:No News

Leave Your Message

  • Click Refresh verification code